ICON A5 - Page 729

PROPULSION / PROPELLER 16-105
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 16
RELATED INFORMATION:
"Propeller Removal From Engine" on page 16-102
"Propeller Assembly" on page 16-93
"Propeller Installation Onto Engine" on page 16-103
16.2.5 Spinner Dome
16.2.5.1 Inspection Instructions
16.2.5.1.1 Remove Spinner Dome
Use the following procedure to remove an existing spinner dome.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
13—Propulsion
Consumables
Tef-Gel
®
TASK INSTRUCTIONS:
1. Mark the spinner dome orientation to the bulkhead so it can be reinstalled at the same orienta-
tion.
2. Remove the six Torx fasteners with a T20 Torx driver. Document the specific fastener and
washer for each mounting hole during removal.