EasyManua.ls Logo

Keba ServoOne - Page 363

Keba ServoOne
493 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11.6.14.6Error13-6(emergencycodeFF00h)
Cause: Sercos option: MDT failure
Suggested steps:
Missing master data telegram. Please check the wiring!
Thedevicewasprobably
disconnectedfromthe
mastercontroller,orthe
masterisoverloaded.
l Pleasecheckthebussystemconnection.Try
toreplacethecables.
l Pleasetrytoreducecomputationalloadonthe
master.
l Trytoincreasethemastercycletime.
11.6.14.7Error13-7(emergencycodeFF00h)
Cause: Sercos option: 2 drives with same address in the ring
Suggested steps:
Please check the configured SERCOS address (parameter 3000 for SERCOS II /
parameter 11040 for SERCOS III)
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
363
11 Alarms & warnings
11.6.14.8Error13-8(emergencycodeFF00h)
Cause: Sercos option: Phase upshift failure
Suggested steps:
Error during phase switching (up-shift) by master. Please check the settings in the
master!
Thedevicewasprobably
disconnectedfromthe
mastercontroller,orthe
masterisoverloaded.
l Pleasecheckthebussystemconnection.Try
toreplacethecables.
l Pleasetrytoreducecomputationalloadonthe
master.
l Trytoincreasethemastercycletime.
11.6.14.9Error13-9(emergencycodeFF00h)
Cause: Sercos option: Phase downshift failure
Suggested steps:
Error during phase switching (down-shift) by master. Please check the settings in the
master!
Thedevicewasprobably
disconnectedfromthe
mastercontroller,orthe
masterisoverloaded.
l Pleasecheckthebussystemconnection.Try
toreplacethecables.
l Pleasetrytoreducecomputationalloadonthe
master.
l Trytoincreasethemastercycletime.

Table of Contents

Related product manuals