Interactive SourceMeter® Instrument Reference Manual Section 6: SCPI c
2461-901-01 A/November 2015 6-173
Example
Clear all statistics in
.
TRACe:STATistics:CLEar "testData"
Clears all statistics in a user-defined buffer
named
.
Also see
Reading buffers (on page 3-2)
Remote buffer operation (on page 3-23)
:TRACe:MAKE (on page 6-165)
:TRACe:STATistics:AVERage? (on page 6-171)
:TRACe:STATistics:MAXimum? (on page 6-173)
:TRACe:STATistics:MINimum? (on page 6-174)
:TRACe:STATistics:PK2Pk? (on page 6-175)
:TRACe:STATistics:STDDev? (on page 6-175)
:TRACe:STATistics:MAXimum?
This command returns the maximum reading value in the reading buffer.
Type Affected by Where saved Default value
Instrument reset
Power cycle
Usage
:TRACe:STATistics:MAXimum?
:TRACe:STATistics:MAXimum? "<bufferName>"
A string that indicates the reading buffer; the default buffers
(defbuffer1 or defbuffer2) or the name of a user-
defined buffer; if no
buffer is specified, defbuffer1 is used
Example
Returns the maximum reading value in the default
buffer, defbuffer1.
TRACe:STAT:MAXimum? "testData"
Returns the maximum reading value in the user-defined
buffer testData.
Also see
Reading buffers (on page 3-2)
Remote buffer operation (on page 3-23)
:TRACe:MAKE (on page 6-165)
:TRACe:STATistics:AVERage? (on page 6-171)
:TRACe:STATistics:CLEar (on page 6-172)
:TRACe:STATistics:MINimum? (on page 6-174)
:TRACe:STATistics:PK2Pk? (on page 6-175)
:TRACe:STATistics:STDDev? (on page 6-175)