Keithley 2461 Reference Manual

Model 2461
Interactive SourceMeter® Instrument Reference Manual Section 6:
SCPI command reference
2461-901-01 A/November 2015 6-133
STATus subsystem
The STATus subsystem controls the status registers of the instrument. For additional information on
the status model, see Status model (on page C-1).
:STATus:CLEar
This function clears event registers and the event log.
Type Affected by Where saved Default value
Command only
Not applicable
Not applicable
Not applicable
Usage
:STATus:CLEar
Details
This command clears the event registers of the Questionable Event and Operation Event Register
set. It does not affect the Questionable Event Enable or Operation Event Enable registers.
Example
:STATus:CLEar
Clear the bits in the registers
Also see
*CLS (on page B-2)
:STATus:OPERation:CONDition?
This command reads the Operation Event Register of the status model.
Type Affected by Where saved Default value
Query only Not applicable Not applicable Not applicable
Usage
:STATus:OPERation:CONDition?
Details
This command reads the contents of the Operation Condition Register, which is one of the Operation
Event Registers.
For detail on interpreting the value of a register, see Understanding bit settings (on page C-16).
Example
:STAT:OPER:COND?
Returns the contents of the Operation
Condition Register.
Also see
Operation Event Register (on page C-8)

Keithley 2461 Specifications

General

Maximum Current	7 A
Power	100 W
Resolution	6.5 digits
Source Measure Unit (SMU)	Yes
DC Voltage	100 V
Maximum Voltage	100 V
Display	5-inch capacitive touchscreen
Connectivity	USB, GPIB
Software	TSP
DC Current	7 A
Current Source Range	0 to 7 A
Voltage Measurement Range	100 mV to 100 V
Current Measurement Range	10 nA to 7 A
Voltage Measurement Resolution	100 nV