Interactive SourceMeter® Instrument Reference Manual Section 7:
Introduction to TSP operation
2461-901-01 A/November 2015 7-43
Instrument identification
These commands store strings that describe the instrument.
localnode.access (on page 8-83)
localnode.gettime() (on page 8-84)
localnode.linefreq (on page 8-84)
localnode.model (on page 8-85)
localnode.password (on page 8-85)
localnode.prompts (on page 8-86)
localnode.prompts4882 (on page 8-97)
localnode.serialno (on page 8-87)
localnode.settime() (on page 8-87)
localnode.showevents (on page 8-88)
localnode.version (on page 8-89)
Miscellaneous
The miscellaneous functions and attributes allow you to control instrument features and functions that
are not category specific.
delay() (on page 8-49)
exit() (on page 8-72)
localnode.linefreq (on page 8-84)
localnode.password (on page 8-85)
localnode.prompts (on page 8-86)
localnode.prompts4882 (on page 8-97)
opc() (on page 8-92)
waitcomplete() (on page 8-340)
upgrade.previous() (on page 8-336)
upgrade.unit() (on page 8-337)
LAN
LAN commands provide options that allow you to review and configure network settings over the
remote interface.
The following commands contain the status of the LAN.
lan.ipconfig() (on page 8-81)
lan.lxidomain (on page 8-82)
lan.macaddress (on page 8-82)
Set up and assert trigger events that are sent over the LAN.
trigger.lanin[N].clear() (on page 8-248)
trigger.lanin[N].edge (on page 8-249)
trigger.lanin[N].overrun (on page 8-249)
trigger.lanin[N].wait() (on page 8-250)
trigger.lanout[N].assert() (on page 8-251)
trigger.lanout[N].connect() (on page 8-252)
trigger.lanout[N].connected (on page 8-252)
trigger.lanout[N].disconnect() (on page 8-253)
trigger.lanout[N].ipaddress (on page 8-254)
trigger.lanout[N].logic (on page 8-255)
trigger.lanout[N].protocol (on page 8-255)
trigger.lanout[N].stimulus (on page 8-256)
To Next Page
Loading...
