Keithley 2461

Section
7: Introduction to TSP operation Model 2461 Interactive SourceMeter® Instrument
Reference Manual
7-48 2461-901-01 A/November 2015
SMU pulse commands
smu.source.pulse.level (on page 8-190)
smu.source.pulsesweeplinear() (on page 8-194)
smu.source.pulsesweeplinearstep() (on page 8-197)
smu.source.pulsesweeplist() (on page 8-200)
smu.source.pulsesweeplog() (on page 8-202)
smu.source.pulsetrain() (on page 8-205)
SMU contact check commands
smu.contact.check() (on page 8-102)
smu.contact.checkall() (on page 8-103)
smu.contact.enable (on page 8-104)
smu.contact.threshold (on page 8-105)
Status model
The status model is a set of status registers and queues. You can use the following commands to
manipulate and monitor these registers and queues to view and control various instrument events.
status.clear() (on page 8-221)
status.condition (on page 8-221)
status.operation.condition (on page 8-223)
status.operation.enable (on page 8-223)
status.operation.event (on page 8-224)
status.operation.getmap() (on page 8-224)
status.operation.setmap() (on page 8-225)
status.preset() (on page 8-226)
status.questionable.condition (on page 8-227)
status.questionable.enable (on page 8-228)
status.questionable.event (on page 8-228)
status.questionable.getmap() (on page 8-229)
status.questionable.setmap() (on page 8-230)
status.request_enable (on page 8-231)
status.standard.enable (on page 8-232)
status.standard.event (on page 8-233)