7: Introduction to TSP operation Model 2461 Interactive SourceMeter® Instrument
7-44 2461-901-01 A/November 2015
GPIB
These commands store the GPIB address and indicate whether GPIB communication is enabled.
gpib.address (on page 8-80)
Reading buffer
Reading buffers capture measurements, ranges, instrument status, and output states of the
instrument.
buffer.clearstats() (on page 8-10)
buffer.delete() (on page 8-11)
buffer.getstats() (on page 8-12)
buffer.make() (on page 8-14)
buffer.save() (on page 8-15)
buffer.saveappend() (on page 8-16)
bufferVar.capacity (on page 8-18)
bufferVar.clear() (on page 8-19)
bufferVar.dates (on page 8-20)
bufferVar.endindex (on page 8-21)
bufferVar.fillmode (on page 8-22)
bufferVar.formattedreadings (on page 8-23)
bufferVar.fractionalseconds (on page 8-24)
bufferVar.logstate (on page 8-25)
bufferVar.n (on page 8-26)
bufferVar.readings (on page 8-27)
bufferVar.relativetimestamps (on page 8-28)
bufferVar.seconds (on page 8-29)
bufferVar.sourceformattedvalues (on page 8-30)
bufferVar.sourcestatuses (on page 8-31)
bufferVar.sourceunits (on page 8-32)
bufferVar.sourcevalues (on page 8-33)
bufferVar.startindex (on page 8-35)
bufferVar.statuses (on page 8-36)
bufferVar.times (on page 8-37)
bufferVar.timestamps (on page 8-38)
bufferVar.units (on page 8-40)
buffer.write.format() (on page 8-41)
buffer.write.reading() (on page 8-43)
printbuffer() (on page 8-93)
Reset
Resets settings to their default settings.
digio.line[N].reset() (on page 8-52)
reset() (on page 8-97)
smu.reset() (on page 8-175)
timer.cleartime() (on page 8-234)
trigger.blender[N].reset() (on page 8-238)
trigger.timer[N].reset() (on page 8-305)
tsplink.line[N].reset() (on page 8-320)
tspnet.reset() (on page 8-330)
To Next Page
Loading...
