Keithley 2461

Section
6: SCPI command reference Model 2461 Interactive SourceMeter® Instrument
Reference Manual
6-182 2461-901-01 A/November 2015
TRIGger subsystem
The commands in this subsystem configure and control the trigger operations, including the trigger
model.
:ABORt
This command stops all trigger model commands on the instrument.
Type Affected by Where saved Default value
Command only
Not applicable
Not applicable
Not applicable
Usage
:ABORt
Details
When this command is received, the instrument stops the trigger model.
Also see
Aborting the trigger model (on page 3-129)
Trigger model (on page 3-107)
:INITiate[:IMMediate]
This command starts the trigger model.
Type Affected by Where saved Default value
Command only
Not applicable
Not applicable
Not applicable
Usage
:INITiate[:IMMediate]
Also see
Trigger model (on page 3-107)
:TRIGger:BLENder<n>:CLEar
This command clears the blender event detector and resets the overrun indicator of blender <n>.
Type Affected by Where saved Default value
Command only
Not applicable
Not applicable
Not applicable
Usage
:TRIGger:BLENder<n>:CLEar
<n>
The blender number (1 or 2)