Keithley 2461

Model 2461
Interactive SourceMeter® Instrument Reference Manual Section 6:
SCPI command reference
2461-901-01 A/November 2015 6-175
:TRACe:STATistics:PK2Pk?
This command returns the peak-to-peak value of all readings in the reading buffer.
Type Affected by Where saved Default value
Query only
Recall settings
Instrument reset
Power cycle
Not applicable
Not applicable
Usage
:TRACe:STATistics:PK2Pk?
:TRACe:STATistics:PK2Pk? "<bufferName>"
<bufferName>
A string that indicates the reading buffer; the default buffers
(defbuffer1 or defbuffer2) or the name of a user-
defined buffer; if no
buffer is specified,
defbuffer1
is used
Example
TRACe:STAT:PK2Pk?
Returns the peak-to-peak reading value in the default
buffer
defbuffer1
.
TRACe:STAT:PK2Pk? "testData"
Returns the peak-to-peak reading value in the user-
defined buffer
testData
.
Also see
Reading buffers (on page 3-2)
Remote buffer operation (on page 3-23)
:TRACe:MAKE (on page 6-165)
:TRACe:STATistics:AVERage? (on page 6-171)
:TRACe:STATistics:CLEar (on page 6-172)
:TRACe:STATistics:MAXimum? (on page 6-173)
:TRACe:STATistics:MINimum? (on page 6-174)
:TRACe:STATistics:STDDev? (on page 6-175)
:TRACe:STATistics:STDDev?
This command returns the standard deviation of all readings in the buffer.
Type Affected by Where saved Default value
Query only
Recall settings
Instrument reset
Power cycle
Not applicable Not applicable
Usage
:TRACe:STATistics:STDDev?
:TRACe:STATistics:STDDev? "<bufferName>"
<bufferName>
A string that indicates the reading buffer; the default buffers
(defbuffer1 or defbuffer2) or the name of a user-
defined buffer; if no
buffer is specified, defbuffer1 is used