Korg Kronos - Page 137

Preparations for sampling Audio Settings
131
ThisoptionwillkeepthegreatestamountofRAMfree
forsampling.However,itrequiresalittletimetowork,
andsothesoundwillstopforatimeaftersampling
ends.Also,ifasongisplayinginSequencermode,the
playbackwillstop.
Becauseofthis,ifyou’ replayingbackasongor
recordin
gmu
ltiplesamplesatonce,it’sprobablybetter
toleaveAutoOptimizeRAMturnedoff.Onceyou’re
finishedsampling,orifyounoticethattheamountof
availableRAMisgettinglow,usetheOptimizeRAM
menucommandtodotheoptimizationmanually.You
canfindthisco
mmandonthemenusoftheSam
pling
pagesinProgram,Combination,andSequencer
modes,aswellasonpagesP0‐4inSamplingmode.
Youcancheckontheremainingamountofmemoryin
SamplingmodeontheP0:Recordingpage,underFree
SampleMemory/Locations.Formoreinformation,see
“0–1f:FreeSam
pleMemory/Locations”onpage 684of
theParameterGuide.
Using the metronome
Themetronomecanbehelpfulwhenyouwanttoplay
aProgramorCombinationataspecifictempoand
sampleyourperformance.
YoucanmakemetronomesettingsinMetronome
Setup,inProgramorCombinationP0:Play–Audio
Input/Sampling.Youmightfinditconvenienttoset
Bus(OUTPUT)SelecttooneoftheInd
iv.1–4outputs,
connectthe(INDIVIDUAL)1–4jackstoamixer,and
monitorthemetronomeviayourmixer.
Automatically setting-up for the desired
sampling method (Auto Sampling Setup)
Ineachmode,AutoSamplingSetupautomatically
makestheappropriatesettingsforthesampling‐
relatedparameters.ForexampleinProgrammodeyou
canusethistomakethenecessarysettingsfor
resamplingyourplayingonaprogram,ortomake
settingsforsamplingonlyanexternalaudiosource
whileyoumonitoryo
urplayingona
program.
However,theseautomaticsettingsassumetypical
situations,soyou’llneedtoadjusttheparametersto
meetyoursituation.
Thisfunctionisavailableinthefollowingpages:
Mode Page
Sampling Sampling P0: Recording
Combination Combination P0: Play– Audio Input/Sampling
Program Program P0: Play– Audio Input/Sampling
Sequencer
Sequencer P0: Play/REC– Preference, Audio
Input/Sampling