Korg Kronos - Page 144

Sampling (Open Sampling System)
138
8. SettheRECSampleSetupModetoStereo.
Withthissetting,thesoundoftheinternalL/R
channelscanbesampledinstereo.
9. SelectIndex.
Ifyouwanttocreateanewindex,presstheCreate
button.
10.Samplethesound.
PresstheSAMPLINGRECswitch,andthenthe
SAMPLINGSTART/STOPswitchtoenterrecord‐
readymod
e
.
Speakthewordyouwanttosample.
Recordingwillstartwhenthelevelexceedsthe
Level–30dBsetting.
PresstheSAMPLINGSTART/STOPswitchtostop
sampling.
11.Playthekeyboard.
Pressthe“OrigKey”keytohearthesoundyou
sampled.
Sampling from the S/P DIF input
Ingeneral,samplingfromtheS/P DIFinputsisvery
similartosamplingfromtheanaloginputs.For
instance,torecordastereosamplefromtheS/P DIF
inputs,setupthesamplingparametersasbelow:
SourceBus:S/P DIFL/R
Resample:Manual
RecordingLevel[dB]:asdesired
Mode:Stereo
Important:Wheneverusingthedigitalinpu
tsand
outputs,makesu
rethattheGlobalSystemClock
parameterissetcorrectly.Formoreinformation,see
“SystemClock”onpage 756oftheParameterGuide.
Applying an insert effect to a sample and
resampling the result
Theprocessofapplyinganinserteffectetc.toa
sampledsoundandthensamplingitonceagainis
called“resampling.”
1. IntheP0:Recording–Recordingpage,assignthe
samplethatyouwanttoresampletoSample
Select.
Whenthepowerisfirstturnedon,theassigned
samplewillbesettoOr
ig.KeyC2.
2.
Makethefollowingsettings.
–INPUT1–
BusSelect(IFX/Indiv.):Off
Turnoffthebussesforallsixaudioinputs.
–SamplingSetup–
SourceBus:L/R
ThesoundsenttotheL/Rwillbesampled.
Trigger:SamplingSTARTSW
Afteryou’vepressedtheSAMPLINGRECswitch
toentersampling‐readymode,resam
plingwill

beginwhenyoupresstheSAMPLING
START/STOPswitch.
Resample:Auto
Thesampleassignedtotheindexwillberesampled
automatically.
Key:C2
UseKeytospecifythesamplethatwillbe
resampled.
RecordingLevel:0.0
Thisisthedefaultsettingforresampling.
Saveto:RAM
ThedatawillbewrittentoRAMmemory
.
SamplingMode:Stereo
Thesoundoftheinte
rnalL/Rchannelswillbe
sampledinstereo.
Auto+12dBOn:On
The+12dBsettingwillautomaticallybeturnedon
forthesamplesyourecord.