2WA/2NJ/2RK-2
6-39
*: Initial setting value is a reference value as the value changes by the adjustment at the production.
5.Change the setting value by using [+] [-] key or the numeric keypad.
For the test pattern 1, increase the value.
For the test pattern 2, decrease the value.
* :When the setting value is increased, the image moves backward, and it moves forward
when the setting value is decreased.
Figure 6-4
6.Press the [Start] key to set the setting value.
Precautions
Check the copy image after the adjustment. If the image is still incorrect, adjust the following in
the maintenance mode.
U034 > U066(P.6-56) > U071(P.6-61)
Duplex
Half(S)
Adjust the leading edge timing for the
duplex copy Half (S)
-3.0 to 3.0 0.1mm 0
Items Contents Setting
range
Data
variation
Initial
setting
Correct image
Output
example 1
Output
example 2
Leading edge
registration
(20 ± 1.0 mm)
To Next Page
Loading...
