2WA/2NJ/2RK-2
6-96
Contents
Mode selection for the operation to remove overcharged toner in the developer unit (Toner apply-
ing mode). Also, sets the operation to take toner accumulated on the developer blade back to the
developer unit (vibration motor control).
Purpose
Change the setting to reduce the toner applying amount. Execute to change the vibration motor
control frequency.
* :Density is lowered if overcharged toner stays in the developer unit.
Method
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
Setting: Timing
1.Select the item to set.
2.Change the setting value by using [+] [-] key or the numeric keypad.
3.Press the [Start] key to set the setting value.
Setting: Mode
1.Select the item to set.
* :Initial setting: Mode1 (1)
2.Press the [Start] key and fix the setting value.
U147 Setting the toner applying mode
(Message: Set Toner Apply Mode)
Items Contents
Timing Sets the toner applying shift timing
Mode Sets the toner applying mode.
Upper limit Sets the upper limit of the toner applying amount for each operation
mode.
Minimum Sets the toner putting width at selecting the cleaning mode.
Items Contents Setting range Data
varia-
tion
Initial setting
90
ppm
80
ppm
70
ppm
Paper Int Sets the toner applying shift counts
(paper interval)
10 to 100 1 Sheet 80 80 70
Job End
Sets the toner applying shift counts
(Job completion)
10 to 100 1 Sheet 12 12 12
Items Contents
Mode0 Set to consume the toner putting operation with less than the normal
amount.
Mode1 Sets the toner putting operation with the normal amount.
To Next Page
Loading...
