12E5119 Instruction Manual QuickTOC
®
ultra
IECEx 107
7 How to Work with the Analyser
7.7 Measurement Settings
LAR | PROCESS ANALYSERS AG
Sensor (user level 3 only):
This value indicates which sensor detects for this channel.
Analog output (user level 3 only):
This value indicates to which analog output this channel is connected.
Limits:
To limit readings and output alarms when the readings are too high or too low, the lower and upper limits
must be set. To set the limits, this function must be activated.
Min. Limit:
This function specifies the lower limit of readings that will be checked for underflow.
Max. Limit:
This function specifies the upper limit of the measured values to be checked for overshoot.
Check function (user level 3 only):
This function can be used to switch the check function on and off.
To Next Page
Loading...