LAR Process Analysers QuickTOC ultra - Flow Diagrams; Component Labelling

12E5119 Instruction Manual QuickTOC
®
ultra
IECEx 255
LAR | PROCESS ANALYSERS AG
12 Flow Diagrams
12 Flow Diagrams
The analyser can be operated with different configurations and methods. Furthermore, several methods
can be used in an analyser.
12.1 Component Labelling
Table 38: Component labelling
Notice
If you have any questions, contact LAR Technical Support (Chapter 15.1
on page 283).
Component Labeling
NDIR 1 B1
NDIR 2 B2
NO detector B3
O2 detector B4
Flow sensor BF1 - BF2
Humidity sensor BM
Pressure display BP1
Pressure sensor BP2
Pressure gauge (Ambient Air Preparation Unit) BP10
Sample vessels CM1 - CM6
Rinsing vessel CM7
Calibration vessel CM8
TIC reactor CM9
Canister (rinsing water) CM10
Canister (phosphoric acid) CM11
Canister (hydrochloric acid) CM12 - CM16
Furnace EB
Gas cooler EC
Air pump (Ambient Air Preparation Unit) GQ
Condensate pump GP1
Sample pump GP2 - GP7
External acidification GP12 - GP17
XY-System GS
Quartz wool filter HQ1
Fine filter HQ2
Activated carbon filter HQ3
Gas filter (Ambient Air Preparation Unit) HQ10
Air-water separator (Ambient Air Preparation
Unit)
HQ11
i