12E5119 Instruction Manual QuickTOC
®
ultra
IECEx 161
LAR | PROCESS ANALYSERS AG
8 Care and Maintenance
8 Care and Maintenance
Only minor effort is required to service and maintain the analyser. This section shows you the best way
to look after your analyser to guarantee trouble-free operation. The documentation of maintenance and
service work is a precondition for any warranty and guarantee claims, and also represents a valuable
aid in locating resolutions when malfunctions occur (Chapter 10 from page 249).
Care and Maintenance:
• Care measures are application-dependent and are recommended by LAR. The effort for
maintenance work is about 30 minutes / week.
• Maintenance includes replacement of consumables and consumables. The cost of maintenance is
about 5 - 10 min / week.
• After maintenance and servicing, some functional tests must always be performed to check analyser
status (Chapter 8.8 on page 200).
Notice
The scope of analyser maintenance and care work depends on the applicati-
on.
All maintenance and care action, and intervals, pertain to the most demanding of ap-
plications and are to be understood as recommendations from LAR..
Notice
If you have any questions about maintenance and / or service, contact LAR Tech-
nical Support (Chapter 15.1 on page 283).
As part of customer support, LAR Technical Support offers customizable
maintenance contracts and device-specific training to extend your know-
how. Further information at: www.lar.com.
i
i
To Next Page
Loading...