12E5119 Instruction Manual QuickTOC
®
ultra
IECEx 207
9 Accessories and Options
9.2 Reagent Cabinet
LAR | PROCESS ANALYSERS AG
9.2.2 Installation of the Reagent Cabinet
Installation of the Reagent Cabinet is dependent on the mounting variant.
Variant 1 (without mounting):
Place the Reagent Cabinet onto the floor or the PVC plate of the mounting rack under the analyser.
Variant 2 (wall mounting):
Fit the Reagent Cabinet with the stud bolts on the wall underneath the analyser.
Variant 3 (Mounting Rack):
Use holes Q1 and Q2 in the mounting rack, and holders Q1 and Q2 on the Reagent Cabinet, for fitting
on the mounting rack (Chapter 9.6 from page 235).
Warning
Do not fit the Reagent Cabinet too high (near to the analyser) because other-
wise the ventilation unit underneath the analyser is difficult to access.
!
To Next Page
Loading...