LAR Process Analysers QuickTOC ultra - General Information; Safety Notes

12E5119 Instruction Manual QuickTOC
®
ultra
IECEx 5
LAR | PROCESS ANALYSERS AG
1 General Information
1 General Information
Read the manual at hand carefully prior to using the analyser.
Keep the manual in a place near the analyser for further reference.
The improper usage of the analyser may void the warranty.
The following symbols are used in this operating manual to highlight instructions:
1.1 Safety Notes
Notice Warning Danger
Danger
The general codes for working with chemicals and electrical equipment must
be observed while using the analyser.
The voltage specified on the nameplate of the analyser must match that of
your power supply.
Bear in mind the hazards potentially emanating from the different waters.
Use protective gloves and goggles as required.
The analyser must be switched off before working on live parts.
For safety reasons, the rear part of the analyser may only be opened by au-
thorised personnel.
When work is carried out in the front part of the enclosure, you must ensure
that the analyser is in Offline mode, and so the XY system is in the Stop posi-
tion. It must not be moving (to prevent hand injuries).
If faults occur when the analyser is running which you cannot rectify yourself,
please contact your local partner or the Technical Support of LAR
(Chapter 15 on page 257).
i
!
x
x