134 Instruction Manual QuickTOC
®
ultra
IECEx 12E5119
7 How to Work with the Analyser
7.10 Calibration LAR | PROCESS ANALYSERS AG
Selection of sample stream:
This function can be used to select the sample stream to be calibrated. Each sample stream must be
calibrated individually.
Settings (user level 3 only):
This function takes you to the "Calibration Settings".
Begin calibration:
This function can be used to start a calibration.
Calibration parameters (user level 3 only):
This function can be used to enable or disable the calibration parameter. Click on a corresponding cali-
bration parameter to access the calibration parameters setting (Chapter 7.10.4 on page 143).
.
Notice
The calibration parameters depend on the method used for the sample
stream.
i
To Next Page
Loading...