MacDon M105 - Page 307

MAINTENANCE AN D SERVICING
NOTE:
Image showing filter head removed to show component
clarity.
7. Remove gasket (C) from groove (B) in filter head (A).
Figure 5.182: Hydraulic System
Installing Return Filter
NOTE:
For filter s
pecifications, refer to Filter Part Numbers,
page 200.
NOTE:
Image showing filter head removed to show component
clarity.
1. Clean the gasket groove (B) in the filter head (A).
2. Apply a thin film of clean oil to the filter gask et (C).
3. Install new gasket into the groove (B) in the filter
head (A).
4. Screw the new filter (D) onto the filter head until the
gasket contacts the filter.
Figure 5.183: Hydraulic System
5. Tighten filter an additional 3/4 turn by hand.
IMPORTAN T:
Do NOT use a filter wrench t o install oil filter.
Overtightening can damage gasket and filter.
6. Check hydra
ulic fluid levels. Refer to Checking and
Filling Hyd
raulic Oil, page 288. For capacity level, refer
to Lubrican
ts, Fluids, and System Capacities, page
199.
Figure 5.184: Hydraulic System
169890 293 Revision A