Oce ColorStream - Creating a New Setup or Changing a Setup

Creating a new setup or changing a setup
Requirements
Requirements for saving setups:
■
The Key Operator or an operator authorized by the Key Operator must be logged on.
■
There can be no error message.
To create a new setup or change a setup
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
On the operator panel, select:
■
For generally valid print job setups:
'Setup' -> 'Job setup' menu
■
For color setups:
'Setup' -> 'Color setup' menu
■
For channel-specific setups:
'Setup' -> 'Setup channel A' / 'Setup channel B' / 'Setup channel C' menu
2.
Select the setup in the 'Setup list' tab.3.
If this setup is not yet loaded, click the 'Load' button.4.
Click on the 'Setup contents' tab and check the settings.5.
Adjust settings as required in the menus under 'Configuration'.6.
Note
An existing link between a job setup and a color setup can be saved at the same
time using the 'Save' button. Using the 'Save as' button, on the other hand,
the link will not be saved.
In both cases, the color setup is not saved at the same time.
Overwrite the setup using the same name (not for "default" setup). Click the
'Save' button.
Or save setup under a new name. To do this:
■
Click the 'Save as' button.
■
Enter the new name in the dialog window.
■
For a color setup, a new Color Setup Verification ID must also be entered.
Whether or not this CSVID has to be entered decimally or hexadecimally
depends on the setting in the 'Emulations' -> 'General' menu under 'Display
of CSVID'.
■
Click the 'Execute' button.
7.
Chapter 5 - Working with the Operator Panel124
Creating a new setup or changing a setup