Cleaning the Paper Path
Caution:
There can be a high build-up of static charge when vacuuming the toner spill.
Always use an industrial vacuum cleaner with a grounded suction tube, rubber nozzle
and filter set for fine dust. For larger toner quantities, the industrial vacuum cleaner must
be explosion-proof.
Caution:
Before cleaning, observe the safety directives in the ‘Cleaning the Printing System —
Overview’ on page 268 section.
To Clean the Paper Path
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button:1.
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Cleaning the printing system' menu
■
'Select cleaning function': 'Clean paper path'
■
Click the 'Next' button.
2.
Caution
The paper input rocker and the paper output flap open automatically.
Do not stand directly in front of the paper input or output.
To start cleaning the paper path, click the 'OK' button.
For information on the icons displayed on the operator panel under 'Steps':
see ‘Explanation of icons’ on page 134.
3.
Caution
Wait until preparation is complete
The doors must not be opened before the relevant message is displayed on the
operator panel.
Chapter 7 - Cleaning the Printing System 289
Cleaning the Paper Path
To Next Page
Loading...
