Refilling Toner (Option: 1 kg / 2.2 lb Toner Bottle)
Caution:
■
Do not allow toner to come into contact with the eyes. In the event of contact with
the eyes, rinse eyes with plenty of cold water and seek medical attention.
■
Avoid contact with the skin. In the event of contact with the skin, wash toner off with
plenty of cold water.
■
Do not inhale toner. Avoid accumulation of dust. If, after inhaling toner, you experi-
ence symptoms such as nausea, headaches or dizziness, go out into the fresh air imme-
diately.
■
Do not spill toner. You can slip on spilled toner. Clean up spilled toner or developer
immediately using a damp cloth or vacuum cleaner. Do not use warm water as it
makes the toner soft and sticky.
■
Always use an industrial vacuum cleaner with a grounded suction tube, rubber nozzle
and filter set for fine dust. For larger toner quantities, the industrial vacuum cleaner
must be explosion proof.
■
Keep toner out of the reach of children and store it away from containers used for
food and drink.
Attention:
■
Only use permitted toner that is suitable for the developer being used.
■
Only use original, sealed toner bottles secured by an intact band.
■
Do not re-use toner.
■
Always store toner in a cool (< 35° C/95° F), dry, and well-ventilated space.
■
Never expose toner to direct heat (sunlight, heaters, etc.)
Note:
The toner for CustomTone colors can be refilled from 1 kg (2.2 lb) toner bottles during
active printing. Depending on the print image, you still have a few minutes after the
warning is displayed before the printing system stops due to lack of toner. However, if
highest levels of print quality are to be maintained, we recommend that the toner from
1 kg (2.2 lb) toner bottles is not refilled during printing since this requires the opening
of a door on the printing system.
Chapter 8 - Replacing Consumables324
Refilling Toner (Option: 1 kg / 2.2 lb Toner Bottle)