Oce ColorStream - Putting the Developer Station on the Stacking Tray

Putting the Developer Station on the Stacking Tray
Caution:
■
Heavy weight
Note the heavy weight of the developer station (approx. 70 kg/145.35 lb) and the
correct functioning of the locks on the replacement cart.
■
Danger of tilting
Lower the developer station to the lowest position of the hoisting lift before transporting
it, otherwise there is an increased danger of tilting on uneven floors.
■
Danger of crushing
There is a danger of injury due to crushing when lowering or raising the hoisting lift.
Keep hands, feet and objects out of the hoisting area.
■
Hot surfaces
After a longer period of printing, the motor of the developer station may be hot. Do
not touch the motor.
Attention:
Avoid damage
Bear in mind the width and height of the replacement cart when moving it.
To Put the Developer Station on a Stacking Tray
#
Proceed as follows:
Carefully lower the developer
station onto the stacking tray.
1.
Chapter 6 - Operating the Printing System 181
Putting the Developer Station on the Stacking Tray