Oce ColorStream - Replacing fine filter

Replacing fine filter
Introduction
The printing system monitors the differential pressure on the fine filter. If the differential
pressure exceeds a warning threshold, a warning is displayed on the operator panel.
Caution:
■
Do not allow toner to come into contact with the eyes. In the event of contact with
the eyes, rinse eyes with plenty of cold water and seek medical attention.
■
Avoid contact with the skin. In the event of contact with the skin, wash toner off with
plenty of cold water.
■
Do not inhale toner. Avoid accumulation of dust. If, after inhaling toner, you experi-
ence symptoms such as nausea, headaches or dizziness, go out into the fresh air imme-
diately.
■
Do not spill toner. You can slip on spilled toner. Clean up spilled toner or developer
immediately using a damp cloth or vacuum cleaner. Do not use warm water as it
makes the toner soft and sticky.
■
Always use an industrial vacuum cleaner with a grounded suction tube, rubber nozzle
and filter set for fine dust. For larger toner quantities, the industrial vacuum cleaner
must be explosion proof.
■
Keep toner out of the reach of children and store it away from containers used for
food and drink.
Attention:
■
The replacement procedure for the fine filter can only take place when printing is
stopped.
■
Keep the used fine filter for collection by Service or the contracted shipping company.
To Replace the Fine Filter
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
Select the following menu on the operator panel:
'Replace consumables' -> 'Replace fine filter'
2.
Chapter 9 - Replacing Expendables 443
Replacing fine filter