Oce ColorStream - Installing the Cleaning Brush of the Photoconductor Unit

Installing the cleaning brush of the photoconductor unit
Caution:
Observe the safety directives in the ‘Replacing the cleaning brush — overview’ on page 433
section.
To Install the Cleaning Brush of the Photoconductor Unit
#
Proceed as follows:
Open packaging and place inter-
lock lid on the new cleaning
brush as shown.
1.
Remove new cleaning brush from the packaging using the interlock lid.2.
Push in cleaning brush to the
stop point and lock (flat side of
the interlock lid to the photocon-
ductor belt).
The gloves are no longer re-
quired.
3.
Chapter 9 - Replacing Expendables 437
Installing the cleaning brush of the photoconductor unit