Replace waste toner box
Introduction
The used developer is also sucked into the waste toner box via a vacuum system. When
the waste toner box has reached its maximum filling level, a warning appears on the op-
erator panel. Depending on the print image, you still have approx. 30 minutes after the
warning is displayed before the printing system stops and displays an error message.
Caution:
■
Do not allow toner to come into contact with the eyes. In the event of contact with
the eyes, rinse eyes with plenty of cold water and seek medical attention.
■
Avoid contact with the skin. In the event of contact with the skin, wash toner off with
plenty of cold water.
■
Do not inhale toner. Avoid accumulation of dust. If, after inhaling toner, you experi-
ence symptoms such as nausea, headaches or dizziness, go out into the fresh air imme-
diately.
■
Do not spill toner. You can slip on spilled toner. Clean up spilled toner or developer
immediately using a damp cloth or vacuum cleaner. Do not use warm water as it
makes the toner soft and sticky.
■
Always use an industrial vacuum cleaner with a grounded suction tube, rubber nozzle
and filter set for fine dust. For larger toner quantities, the industrial vacuum cleaner
must be explosion proof.
■
Keep toner out of the reach of children and store it away from containers used for
food and drink.
Attention:
■
The waste toner box can only be replaced when printing is stopped.
■
Do not re-use toner.
■
Keep used toner ready for collection by Service or the contracted shipping company.
To Replace the Waste Toner Box
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Ready' button.1.
Chapter 8 - Replacing Consumables 331
Replace waste toner box
To Next Page
Loading...
