Oce ColorStream - Printing Test Pages for Color Calibration

Printing Test Pages for Color Calibration
Introduction
Requirements for printing test pages for color calibration:
■
The printing system is in the 'Stop' status.
■
No other print job must be active.
■
The channel must be deactivated ('Channels' menu).
Note:
The widest possible paper should be used to allow you to print and test as many blocks
as possible. The minimum paper width is 6,5“ = 165 mm.
To Print Test Pages for the Color Calibration
#
Proceed as follows:
Select the following menu on the operator panel: 'Configuration' -> 'Color' -
> 'Calibrate color' -> 'Print' menu.
The current configuration of the printing system is established and displayed
on the right of the menu page.
1.
Note
The wider the paper, the more test strips can be printed and checked.
If you wish to change this configuration:
■
Insert the paper web that is to be used to calibrate the printing system.
Make the relevant settings in the 'Paper' menu.
■
Load the desired raster kit in the 'Raster' menu.
■
Switch to the required color configuration in the 'Configurator' menu.
2.
If you change the configuration:
■
Go back to the 'Calibrate color' -> 'Print' menu.
■
Click the 'Next' button.
3.
Chapter 6 - Operating the Printing System246
Printing Test Pages for Color Calibration