Oce ColorStream - Removing the Developer Station

Removing the Developer Station
Removing the developer station
Caution:
■
Heavy weight
Note the heavy weight of the developer station (approx. 70 kg/145.35 lb) and the
correct functioning of the locks on the replacement cart.
■
Danger of tilting
Lower the developer station to the lowest position of the hoisting lift before transporting
it, otherwise there is an increased danger of tilting on uneven floors.
■
Danger of crushing
There is a danger of injury due to crushing when lowering or raising the hoisting lift.
Keep hands, feet and objects out of the hoisting area.
■
Hot surfaces
After a longer period of printing, the motor of the developer station may be hot. Do
not touch the motor.
Attention:
Avoid damage
Bear in mind the width and height of the replacement cart when moving it.
To Remove the Developer Station
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button:1.
If not all developer stations have been swiveled off in the relevant print unit,
select the following menus and elements on the operator panel:
■
'Replace consumables' -> 'Swivel developer stations' menu
■
'Select task': 'All - upper print unit' or 'All - lower print unit'
■
'Select action to be executed': 'Swivel off'
■
Click the 'Next' button.
■
Click the 'OK' button to start the swiveling process.
The developer stations are swiveled off.
■
When swiveling off is finished, click the 'OK' button again.
2.
Chapter 6 - Operating the Printing System 171
Removing the developer station