Oce ColorStream - Checking the Paper Path

Checking the Paper Path
Caution:
Before cleaning, observe the safety directives in the ‘Cleaning the Printing System —
Overview’ on page 268 section.
To Check the Paper Path
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button:1.
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Cleaning the printing system' menu
■
'Select cleaning function': 'Check paper path'
■
Click the 'Next' button.
2.
Caution
The paper input rocker and the paper output flap open automatically.
Do not stand directly in front of the paper input or output.
Click the 'OK' button to start checking the paper path.
Information on the icons displayed on the operator panel under 'Steps':
‘Explanation of icons’ on page 134
3.
Caution
Wait until preparation is complete
The doors must not be opened before the relevant message is displayed on the
operator panel.
Open all doors on the printing system:
■
‘Opening Right Doors’ on page 157.
■
‘Opening Left Doors’ on page 161.
4.
Chapter 7 - Cleaning the Printing System296
Checking the Paper Path