Oce ColorStream - Converting the Printing System

Converting the Printing System
Prerequisites
The following prerequisites have to be satisfied for conversion of the printing system:
■
The relevant activation is installed.
■
The access ticket has been requested.
■
The printing system is in the 'Stop' or 'Operator intervention necessary' status.
To Convert the Printing System
#
Proceed as follows:
On the operator panel, select the 'Configuration' -> 'Print parameters' ->
'Configurator' menu.
1.
Select the desired printer type under 'Selecting the printer type'.2.
Select whether 'I mode support of PDF containers' is required.3.
Click the 'Next' button and select the available settings one after the other,
e.g.
■
Print Speed
■
Color Setup
By loading a setup, all settings are made that were saved for the selected
printer type.
■
Job Setup
■
Raster kit
If necessary, you can return to the previous menu window using the 'Back'
button.
4.
Note
Raster angle, tone transfer curve sets and coloration levels are automatically
set depending on the configuration.
Chapter 6 - Operating the Printing System 261
Converting the Printing System