Oce ColorStream - Removing the Cleaning Brush of the Transfer Unit

Removing the cleaning brush of the transfer unit
Caution:
Observe the safety directives in the ‘Replacing the cleaning brush — overview’ on page 433
section.
To Remove the Cleaning Brush of the Transfer Unit
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
On the operator panel, select the following menus and elements:
■
Menu 'Replace consumables' -> 'Replace brush'
■
'Select print unit': 'Upper print unit' or 'Lower print unit'
■
'Select assembly': 'Transfer unit'
■
Click the 'Next' button.
2.
Click the 'OK' button to start the replacement of the cleaning brush.
The brush exchange is being prepared. The developer stations are swiveled off.
Information on the icons displayed on the operator panel under 'Steps': see
‘Explanation of icons’ on page 134.
3.
Caution
Wait until preparation is complete:
The doors must not be opened before the relevant message is displayed on the
operator panel.
Open all doors on the right-hand side of the printing system.4.
Caution
This can soil hands and clothing.
Wear the gloves provided in the packaging.
Chapter 9 - Replacing Expendables 439
Removing the cleaning brush of the transfer unit