The procedure for replacing a transfer belt is different for the upper and lower print units:
Upper print unit:
■
‘Removing the Transfer Belt in the Upper Print Unit - Preparation’ on page 376
‘Removing Transfer Belt in the Upper Print Unit’ on page 380
■
‘Insert the Transfer Belt in the Upper Print Unit’ on page 385
‘Insertion of a Transfer Belt in the Upper Print Unit (Completion)’ on page 392
Lower print unit:
■
‘Removing the Transfer Belt in the Lower Print Unit - Preparation’ on page 395
‘Removing the Transfer Belt in the Lower Print Unit ’ on page 398
■
‘Inserting the Transfer Belt in the Lower Print Unit’ on page 402
‘Inserting the Transfer Belt in the Lower Print Unit’ on page 408
The procedure for running in a photoconductor belt or transfer belt is the same for all
types of belt:
■
‘Running in a Belt’ on page 411
Chapter 9 - Replacing Expendables 351
Replacing the Belt — Overview
To Next Page
Loading...
