Oce ColorStream - Swiveling on Developer Stations

Swiveling on developer stations
To Swivel on a Developer Station
#
Proceed as follows:
Switch printing system on.1.
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Swivel developer stations' menu
■
'Select task':
All developer stations in a print unit at the same time ('All - upper print
unit' / 'All - lower print unit')
'Individual developer station' or
■
'Select action to be executed': 'Swivel on'
■
If developer stations are to be swiveled individually:
'Select print unit': 'Upper print unit' or 'Lower print unit'
'Select developer station': 'Station 5:' to 'Station 1:' (it is essential to note
the following sequence: 1 - 2 - 3 - 4 - 5)
■
Click the 'Next' button.
2.
To start the swivel on process for the selected developer stations, click on the
'OK' button.
Information on the icons displayed on the operator panel under 'Steps': ‘Expla-
nation of icons’ on page 134.
3.
To complete the swivel on process for the selected developer stations, click on
the 'OK' button.
The printing system remains in the 'Special functions' status.
4.
Only if another developer station needs to be swiveled on individually: Repeat
steps from step 2.
5.
To complete swiveling on the developer stations:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
6.
Chapter 7 - Cleaning the Printing System282
Swiveling on developer stations