Oce ColorStream - Cleaning the Developer Station Shelf (Optional)

Cleaning the Developer Station Shelf (Optional)
Caution:
■
Heavy weight
When fully equipped with 4 developer stations, the developer station shelf weighs
approx. 360 kg/800 lb. Secure the developer station shelf to prevent it from rolling
away. Take care on steep slopes and ramps.
■
Hot surfaces
After a longer period of printing, the motor of the developer station may be hot. Do
not touch the motor.
Caution:
There can be a high build-up of static charge when vacuuming the toner spill.
Always use an industrial vacuum cleaner with a grounded suction tube, rubber nozzle
and filter set for fine dust. For larger toner quantities, the industrial vacuum cleaner must
be explosion-proof.
Attention:
The developer station shelf must not be cleaned while developer stations are fitted.
Liquid or dirt could get inside a developer station and damage or destroy it.
To Clean the Developer Station Shelf
#
Proceed as follows:
If the developer station shelf is not empty: Use the hoisting lift to remove all
developer station and place them on a stacking tray (see ‘Removing the Devel-
oper Station from the Developer Station Shelf’ on page 183).
1.
Remove large amounts of dust or toner using the vacuum cleaner.2.
Clean the surfaces of the developer station shelf using a soft, dry cloth. If nec-
essary, use a lightly damp cloth (water with a small amount of washing-up
liquid) that has been wrung out.
3.
Remove any dirt jammed into the casters.4.
If required: Use the hoisting lift to replace the developer stations in the devel-
oper station shelf (see ‘Storing the Developer Station in the Developer Station
Shelf’ on page 177).
5.
Chapter 7 - Cleaning the Printing System 309
Cleaning the Developer Station Shelf (Optional)