Oce ColorStream - Filling a Toner Box

Filling a Toner Box
Introduction
Note:
The developer station toner boxes normally always contain a sufficient amount of toner,
as toner is automatically fed from the toner bottle to the toner box when required. Filling
a toner box will therefore only be necessary in exceptional cases. It is only possible to fill
a toner box in the 'Ready' or 'Operator intervention necessary' status.
To Fill the Toner Box
#
Proceed as follows:
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Fill toner box' menu
■
'Select print unit': 'Upper print unit' or 'Lower print unit'
■
'Select developer station'
■
Click the 'Next' button.
1.
Click the 'OK' button to start filling the toner box.
Information on the icons displayed on the operator panel under 'Steps': see
‘Explanation of icons’ on page 134.
2.
Exit toner box filling:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration approx. two minutes)
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
3.
Chapter 8 - Replacing Consumables 335
Filling a Toner Box