Replacing Expendables in Expert Mode
Attention:
It is only possible to replace expendables in expert mode when print operation is stopped.
Note:
Each expendable can be replaced individually and independently of the other expendables.
With expert mode, however, several expendables, which will soon reach the end of their
remaining service life, can be replaced together. As the necessary preparation and com-
pletion phases for replacing expendables are only executed once in expert mode, the time
required is significantly reduced.
To Replace Expendables in Expert Mode
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
Select the following menu on the operator panel:
'Replace consumables' -> 'Expert mode' menu
2.
To start the replacement of expendables in expert mode, click the 'Start' button.
The replacement is being prepared; this can take up to two minutes.
3.
Caution
Wait until preparation is complete.
The doors must not be opened before the relevant message is displayed on the
operator panel.
#
Open the doors on the printing system:
■
‘Opening Right Doors’ on page 157.
■
‘Opening Left Doors’ on page 161.
4.
Chapter 9 - Replacing Expendables 469
Replacing Expendables in Expert Mode
To Next Page
Loading...
