Proceed as follows:
Complete the replacement of the smoothing rollers on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration approx. two minutes)
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
17.
Chapter 9 - Replacing Expendables468
Installing smoothing rollers
To Next Page
Loading...
