Oce ColorStream - Importing a Setup

Importing a Setup
Introduction
You can apply all setups that were created on another printing system Océ ColorStrea-
musing the same software version.
To Import a Setup
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
On the operator panel, select:
■
For print job setups:
'Setup' -> 'Job setup' menu
■
For color setups:
'Setup' -> 'Color setup' menu
■
For channel-specific setups:
'Setup' -> 'Setup channel A' / 'Setup channel B' / 'Setup channel C' menu
2.
Note
When importing setups, existing links between job and color setups will be
taken into account.
Click the 'Import' button.3.
Select where the setup is to be imported from:
■
USB memory stick
■
Transfer area (a directory on the drive of the controller hard disk; used for
remote data transfer of setups)
4.
Caution
Follow virus protection instructions
When importing from a USB memory stick, ensure that there are no viruses
on the USB memory stick.
Chapter 5 - Working with the Operator Panel 125
Importing a Setup