Oce ColorStream - Draining the Developer Mixture

Draining the Developer Mixture
Caution:
Observe the safety directives in the ‘Replacing the Developer - Overview’ on page 336 section.
Attention:
The used developer mixture is sucked into the waste toner box via a vacuum system.
Before draining the developer mixture, check whether there is still enough space for it in
the waste toner box; you should also ensure that the waste toner box can still be lifted
out when filled with the additional developer mixture (approx. 5.5 kg/12.1 lb). Otherwise,
the waste toner box must be changed first (see ‘Replace waste toner box’ on page 331).
To Drain the Developer Mixture
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Ready' button:1.
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Replace developer' menu
■
'Select print unit': 'Upper print unit' or 'Lower print unit'
■
'Select developer station': 'Station 1:' to 'Station 5:'
■
'Select action': 'Drain mixture'
■
Click the 'Next' button.
2.
Click the 'OK' button to start developer replacement.
For information on the icons displayed on the operator panel under 'Steps':
see ‘Explanation of icons’ on page 134.
3.
Caution
Wait until preparation is complete:
The doors must not be opened before the relevant message is displayed on the
operator panel.
Chapter 8 - Replacing Consumables 337
Draining the Developer Mixture