Oce ColorStream - Replacing the cleaning felt

Replacing the cleaning felt
Caution:
Risk of slipping
When removing the slide-in unit oil can drip on the floor. In this case, wipe the oil off
with an absorbent cloth.
Attention:
■
The replacement procedure can only take place when printing is stopped.
■
Cleaning felt may only be used for the purpose for which it was originally intended.
■
If the cleaning felt had an extremely short service life, the cause of the problem must
be identified to prevent further damage.
Note:
The cleaning felt can be replaced when the paper web is inserted.
To replace the cleaning felt
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
On the operator panel, select the following menus and elements:
■
Menu 'Replace consumables' -> 'Replace cleaning felt'
■
'Select cleaning felt': 'Upper and lower' or 'Upper only' or 'Lower only'
■
Click the 'Next' button.
2.
To start replacement of the cleaning felt, click the 'OK' button.
The cleaning felt replacement is being prepared.
Information on the icons displayed on the operator panel under 'Steps': see
‘Explanation of icons’ on page 134.
3.
Caution
Wait until preparation is complete:
The doors must not be opened before the relevant message is displayed on the
operator panel.
Chapter 9 - Replacing Expendables448
Replacing the cleaning felt