Removing the reload corotron slide-in unit of the transfer
unit
Attention:
Observe the safety directives in the ‘Replacing the corotron — overview’ on page 412 section.
Note:
A reload corotron is only used in the upper print unit in the transfer unit.
To Remove the Reload Corotron Slide-in Unit of the Transfer Unit
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Replace corotrons' menu
■
'Select print unit': 'Upper print unit'
■
'Select assembly': 'Transfer unit'
■
'Select corotron': 'Charge'
■
Click the 'Next' button.
2.
Click the 'OK' button to start corotron replacement.
Replacement of the corotron is being prepared.
For information on the icons displayed on the operator panel under 'Steps':
see ‘Explanation of icons’ on page 134.
3.
Caution
Wait until preparation is complete
The doors must not be opened before the relevant message is displayed on the
operator panel.
Open the door shown on the
right-hand side of the printing
system.
4.
Chapter 9 - Replacing Expendables 421
Removing the reload corotron slide-in unit of the transfer unit
To Next Page
Loading...
