Oce ColorStream - Scanning Test Pages for Color Calibration

Scanning Test Pages for Color Calibration
Introduction
The measuring device required for the manual scanning of the test print pages is supplied
with all Océ ColorStream printing systems by default; the guide rail and clipboard are
also provided.
Note:
■
The scan program can be operated independently of the other operator panel compo-
nents. This means that you can continue to print with the printing system while
scanning.
■
The scan program can also be installed and operated on a separate PC. When the
Printing System Manager is started, it provides a link via which you can download
the scan program. The data can then be imported via a USB stick connected to a
USB port on the printing system. For more information, please contact your Service
center.
The following describes the scanning process using the operator panel PC of the
printing system.
■
If the measuring device is not used for long periods, it should be stored in its original
packaging until it is next required.
Note:
White balancing adapts the measuring device to differing lighting conditions in the
room.
To Scan Test Pages for the Color Calibration
#
Proceed as follows:
If you have not yet selected the 'Record' menu, choose the following on the
operator panel:
'Configuration' -> 'Color' -> 'Calibrate color' -> 'Record' menu
1.
Click the 'Start scanning program' button.2.
Chapter 6 - Operating the Printing System 249
Scanning Test Pages for Color Calibration