Oce ColorStream - Printing Test Print Jobs - Overview

Printing Test Print Jobs
Printing Test Print Jobs — Overview
Introduction
Preinstalled test print jobs can be started via the 'Test print' menu. These print jobs,
which are grouped in test sequences, can be used to optimize the print quality for a certain
application. These optimized settings can then be saved in a setup.
Prerequisites:
■
The printing system must be in the 'Stop' status.
■
The channel must be deactivated ('Channels' menu).
Some elements of the current printing system configuration are shown under 'Display':
■
Type of printing system and currently used color stations
■
'Print image' -> 'Print mode' menu: 'Simplex' or 'Duplex'
■
'Print image' -> 'Paper output' menu: 'Face up' or 'Face down'
Note:
The test print is always printed using the current printing system configuration. Ensure
that the activated raster and the activated output profile match up correctly (see 'Raster'
and 'Parameter' menus).
To Activate a Test Print:
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button.1.
If the channel is still not deactivated, deactivate the channel in question in the
'Channels' menu.
2.
Select the following menu on the operator panel:
'Configuration' -> 'Emulations' -> 'Test print'.
3.
Under 'Test job selection', select a test print for the relevant configuration.4.
Click the 'Start test print' button.
The display changes from red to green. The test job is only printed until the
test print is canceled.
5.
Chapter 6 - Operating the Printing System200
Printing Test Print Jobs — Overview