Oce ColorStream - Cleaning the Surface of the Developer Stations - Overview

Cleaning the Surface of the Developer
Stations
Cleaning the Surface of the Developer Stations — Overview
Caution:
■
The motor covers of the developer stations can be hot after extended printing.
Touching these components can result in burns.
Let the developer stations cool down, and put on heat-protecting gloves.
■
Also observe the other safety directives in the ‘Cleaning the Printing System — Overview’
on page 268 section.
Attention:
When vacuuming the toner, do not scratch the roller.
Use only a plastic or rubber attachment on the vacuum.
To Clean the Surfaces of the Developer Stations
#
Proceed as follows:
‘Swiveling off Developer Stations’ on page 274.1.
‘Cleaning Developer Station Surface’ on page 275.2.
‘Swiveling on developer stations’ on page 282.3.
Chapter 7 - Cleaning the Printing System 273
Cleaning the Surface of the Developer Stations — Overview