Replacing the Cleaning Brush
Replacing the cleaning brush — overview
Caution:
■
Avoid contact with the skin and wear gloves.
■
In the event of contact with the skin, wash toner off with plenty of cold water.
Attention:
■
The replacement procedure can only take place when printing is stopped.
■
Cleaning brushes may only be used for the purpose for which they were originally
intended.
■
If the cleaning brush had a short service life, the cause of the damage must be clarified
in order to prevent further damage.
Note:
The cleaning brush can be replaced when the paper web is inserted. The paper will not
come into contact with toner.
Overview
The procedure is the same for the upper and the lower print unit:
■
‘Removing the cleaning brush of the photoconductor unit’ on page 434
■
‘Removing the cleaning brush of the transfer unit’ on page 439
Chapter 9 - Replacing Expendables 433
Replacing the cleaning brush — overview
To Next Page
Loading...
