Oce ColorStream - Page 432

Proceed as follows:
Remove the change receiver in
an upwards motion.
14.
Install all other corotron wires (repeat from step 12 in each case).15.
Re-insert the corotron slide-in unit:
■
‘Installing the cleaning corotron slide-in unit or charge corotron slide-in unit
of the photoconductor unit ’ on page 416
■
‘Installing the cleaning corotron slide-in unit of the transfer unit ’ on page 420
■
‘Installing the reload corotron slide-in unit of the transfer unit’ on page 423
■
‘Installing the recharge corotron slide-in unit of the transfer unit’ on page 427
16.
Chapter 9 - Replacing Expendables432
Replacing corotron wire