Oce ColorStream - Emptying Condensation Water

Emptying Condensation Water
Introduction
By default, the condensation water that is created during operation of the heat exchanger
and the recooler is routed directly into the domestic drains.
If this is not possible, the provided containers should be used. The fill level is monitored
here by a water level indicator.
Note:
Before the two 9 V-E block batteries of the water level indicator become flat, a warning
will sound every 2–3 minutes. The batteries must then be replaced.
To empty the condensation water
#
Proceed as follows:
If necessary, insert the hose in
the second container and empty
the full container.
1.
Chapter 6 - Operating the Printing System 263
Emptying Condensation Water