Swiveling off Developer Stations
To Swivel off the Developer Stations
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button:1.
On the operator panel, select the following menus and elements:
■
'Replace consumables' -> 'Swivel developer stations' menu
■
'Select task':
All developer stations in a print unit at the same time ('All - upper print
unit' / 'All - lower print unit')
or 'Individual developer station'
■
'Select action to be executed': 'Swivel off'
■
If developer stations are to be swiveled individually, then also:
'Select print unit': 'Upper print unit' or 'Lower print unit'
'Select developer station': 'Station 5:' / ... / 'Station 1:'
■
Click the 'Next' button.
2.
To start the swivel off process for the selected developer stations, click the 'OK'
button.
For information on the icons displayed on the operator panel under 'Steps':
see ‘Explanation of icons’ on page 134.
3.
To complete the swivel off process for the selected developer stations, click the
'OK' button.
The printing system remains in the 'Special functions' status.
4.
Only if another developer station is to be swiveled off individually: repeat the
work steps from step 2.
5.
#
Cleaning developer station surface see ‘Cleaning Developer Station Surface’ on
page 275.
6.
Chapter 7 - Cleaning the Printing System274
Swiveling off Developer Stations
To Next Page
Loading...
