Oce ColorStream - Replacing Expendables - Overview

Replacing Expendables — Overview
Replacing expendables
This section describes in detail all the steps required to replace expendables. It also provides
the order numbers and package units for all expendables.
Overview
In section ‘Order Numbers and Packaging Units for Expendables’ on page 349 you will find
a list of all the order numbers and packing units for the expendables.
Note:
A warning is displayed on the operator panel before the service life of an expendable
ends.
You can check the current counter values and the respective limit values for each expend-
able in the 'Consumable history' menu.
Note:
Each expendable can be replaced individually and independently of the other expendables.
With expert mode, however, several expendables, which will soon reach the end of their
remaining service life, can be replaced together. As the necessary preparation and com-
pletion phases for replacing expendables are only executed once in expert mode, the time
required is significantly reduced.
#
See sectionExpendable
‘Replacing the Belt — Overview’ on page
350
Photoconductor belt in the upper print
unit
Photoconductor belt in the lower print
unit
Transfer belt in the upper print unit
Transfer belt in the lower print unit
Chapter 9 - Replacing Expendables346
Replacing Expendables — Overview